Hi-Touch Imaging Technologies BS-G400 - Manual (Page 9)

8
5. BS-G400 Standalone Printing
Standalone Printing
1. Insert memory card
Please insert the correct memory card in the printer memory card slot that will make the
printing process successfully, because the photo files will come from your memory card when
BS-G400 printing in standalone printing situation.
*
2. Print photos without a PC
When you finished those steps as below, you can use the LCD Controller to process the
printer output.
A. Set up the printer
(Please see ‘Install BS-G400’ for detail)
B. Install ribbon cartridge
(Please see ‘Install BS-G400’ for detail)
C. Load dedicated photo papers
(Please see ‘Install BS-G400’ for detail)
D. Power up the printer
(Please see ‘Install BS-G400’ for detail)
E. Insert memory card
(Please see ‘Standalone Printing’ for detail)
You can get the information about ‘How to use the LCD Controller’ from ‘Home Menu
Introduction’
Note
The
Memory Stick duo and xD memory card can be used on BS printer only when a USB card reader or adapter is used.
When you insert the SM/SD/MMC/MS card and the top of home menu will show the number ‘1’, when you use the
CF/Micro Drive card and the top of home menu will show the number’2’. If you use these slots at same time but just
one card in the slot will be used.