Honeywell HZC-855PX - Manual (Page 15)

- 15 -
⑧ MAX FIELDS (option)
: Use for compensating the low illumination condition. In case that use
this function because of low illumination condition, adjust maximum
integration fields to get brighter and dynamical image. But the scene
becomes slower than OFF mode. The larger max fields is,
simultaneously the noise of image is larger. This is phenomenon
because too small video output is integrated on many fields memory.
To get more dynamical image, adjust maximum integration fields
and set maximum AGC gain as HIGH, then make better the
standard of dynamic image.
MAX FLDS OFF → 2FLDS → 3FLDS → 4FLDS → 5FLDS
→ 6FLDS → 7FLDS → 8FLDS → …. →
→ 80FLDS → 160FLDS→ 320FLDS
→ 510FLDS
☞caution
1. In Fields Integration mode, noises as well as video information are
increased. When an ambient temperature keeps high, CCD pixel
defect happens to be larger and white. This is not due to failure.
5.7 White Balance Mode
① White Balance Mode
: Outer illumination condition is expressed by Color temperature,
Kelvin (°K). It is White Balance that shows white as white in any
illumination conditions. It is composed of five modes..
ATW ( Auto Trace White balance )
: Trace automatically under any condition in range 2,800°K ~ 8,000°K
( It can be adjustable red and blue point of desired white position. )
AWB
: Consider current illumination condition, do white balance by force
and lock as manual
INDOOR
: Use to set the preset illumination condition as 3200°K
OUTDOOR
: Use to set the preset illumination condition as 5400°K
MANUAL
: Use to adjust to desired RED, BLUE gain manually.
AWC
: Consider current illumination condition, do white balance by
force and lock as manual
② White Balance Mode Control
: It displays and changes White Balance Mode Control status of
Camera. ( According to Mode, it just display the state and not to
adjust.)
ATW AUTO
INDOOR 3200°K
OUTDOOR 5400°K
MANUAL R/B CONT
AWC LOCK → PUSH → . . . .
AWB AUTO
(LOCK means Manual white balance status. Press NEAR(+) /
FAR(-) key continuously, LOCK mode becomes PUSH mode and
white balance acts automatically, and then white balance mode is
locked as manual.)
<< WB MODE >>
MODE ATW
CONTROL FRAME
RED GAIN NOT USE
BLUE GAIN NOT USE
RETURN
<Fig5-7. WB MODE >
<< SETUP MENU >>
LENS MODE
AE MODE
WB MODE
NIGHTSHOT MODE
BLC/WDR MODE
PZM SETTING
CAMERA ID SETTING
SPECIAL FUNCTION
FACTORY DEFAULT