Hitachi StarBoard BT2G-061101 - Manual (Page 17)

2-1
StarBoard
BT-2G Usage Procedures
English
2. Usage Procedures
This section describes the basic procedures for using StarBoard.
2.1 How to use tablet
This section describes how to use the tablet.
2.1.1 Changing the battery in the tablet
The tablet contains 2 AA Ni-MH batteries. If the LED indicator is solid red, change the
batteries as described below. Note that battery life is approximately 24 hours under
normal usage.
(1) Open the battery cover in the backside of the tablet.
(2) Remove the AA Ni-MH batteries contained in the battery cover, and insert full-
charged cells as described below.
(3) Close the battery cover.
Be sure to orient the battery correctly.
If too much force is applied when closing the rear part of the stylus pen, the pen may be
damaged.
CAUTION
Keep the following points in mind when installing the StarBoard.
・ Avoid leaving tablet and stylus pen in locations that are dusty, extremely hot, cold, or
humid. Also avoid leaving in locations exposed to direct sunlight.
BT-2G tablet locations