Hitachi StarBoard BT2G-061101 - Manual (Page 19)

2-3
StarBoard
BT-2G Usage Procedures
English
3. The blue LED will blink continuously during connecting to PC.
4. The blue LED will be solid when the pen is detected within active area.
- USB mode
1. When USB cable is initially connected to the tablet, the red LED will
flash once and the blue LED will blink continuously.
2. The blue LED will be solid when the pen is detected within active area.
.
2.2 Using the Stylus Pen
This section describes how to use the StarBoard stylus pen.
2.2.1 How to use Stylus Pen
The stylus pen has a ON/OFF switch. Battery life can be prolonged by ON/OFF the
switch. To use the stylus pen, set the power switch of the stylus pen to the ON position.
Bluetooth Mode USB Mode Condition
Blue LED Red LED Blue LED Red LED
Power on Flash once Flash once
USB cable plugged Blink
continuously Flash once
Connecting Blink
continuously
Off Blink
continuously
Off
Pen tip on active
area of the tablet Off Off Off Off
Pen within active
area (not touched) Solid Off Solid Off
Low battery Off Solid
ON/OFF switch