Harman Stove Company SF160 - Manual (Page 5)

5
3-90-70742R11_05/13
Installation
Getting Started
The sheet metal sides and top are easily removed to reduce
the chance of dents and/or scratches in the finish. simply
lift the top off, and that will allow the sides to be pulled away
and up, for removal. To re-install, slide the channel, at the
bottom of each side piece, over the lip at the bottom of the
boiler, and hold downward while moving the side panel into
place. Then slide the top down over the sides.
NOTE: The sheet metal top holds the sides in place,
thus, no bolts or screws are needed.
CAUTION: BOILER SHOULD NOT BE INSTALLED
CLOSER THAN 36 INCHES (915 MM) TO ANY
COMBUSTIBLE MATERIAL
Locating Boiler
Place the boiler as close to the chimney as possible, while
still maintaining the above mentioned clearances. Bolt the
shaker handle on to the block on the side of the boiler, using
the (2) 5/16 X 3/4 in. bolts and lock-washers.
Assembly
Install the Temperature/Pressure Gauge into the pipe stub
in the center of the round plate on the front of the boiler
(fIG. 1)
Install the a350 sensor wire all the way into the immersion
well and screw the well into one of the top hole
Turn the pressure relief valve into the stub on top of the
boiler, next to the supply outlet fitting.
NOTE: Use Teflon tape to seal the threads on all fittings.
Any unused fittings must be plugged
Bolt the two manual draft controls through the holes in the
top load door. (fIG. 2) The draft control knob should spin
freely and open to a distance of approximately 3/8 in. from
the door surface, while being able to close against the door
surface.
FIG. 2
3/8 to 1/2 in.
Immersion
Well
Temp/Pressure
Gauge
Optional
Electric Back-up
Elements
automatic Draft Control
Pressure Relief Valve
FIG. 1
Johnson
Controls
aquastat
and Terminal
Block
shaker Handle
Domestic Hot
Water Coil Option