Harley-Davidson FISHER-PRICE 73218 - Manual (Page 12)

12
Assembly
7
TM
• The right footboard was inserted in the vehicle frame at
the factory. Make sure the right footboard is in place.
• Insert two #8 x 3 /
4
" screws into the right footboard
as shown. Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
Right
Footboard
Vehicle
Frame
TM
6
• Fit the motor harness wires between the retainer tabs so
that all four motor harness wires are contained in the
narrow rectangular opening.
• Fit the tabs on the top of one motor harness connector
into the slots in the bottom of the other motor harness
connector and squeeze firmly to re-join the two motor
harness connectors (see inset).
Motor Harness
Connectors
Narrow
Rectangular
Opening 5
Motor Harness
Connectors
Retainer
Tabs
Top View
• Fit the tabs on the left footboard into the slots in the left
side of the vehicle frame. Make sure both tabs are in
the slots.
Hint: You may need to squeeze the left footboard in order
to align the tabs with the slots.
• Insert two 3 /
4
" screws into the left footboard as shown.
Tighten the screws using a Phillip screwdriver.
Do not over-tighten.
Left
Footboard
Tab
Tab
Slots
TM
4
• Insert four #8 x 3 /
4
" screws through the vehicle body and
into the vehicle frame. Make sure the holes in the
vehicle body and frame are aligned.
• Tighten the screws using a Phillips screwdriver.
Do not over-tighten.
Vehicle
Frame
Vehicle
Body
73218pr-0920.qrk 5/21/01 2:29 PM Page 12