Harley-Davidson FISHER-PRICE 73218 - Manual (Page 15)

Assembly
TM
Steering
Bushing
Steering
Bushing
Vehicle
Frame
Neck
• Position the vehicle frame so that the front faces you.
• Fit a steering bushing on top of the neck of the
vehicle frame.
• Fit the other steering bushing underneath the neck.
• Insert two #8 x 3 /
4
" screws through the side of each
steering bushing and into the neck. Tighten all four
screws using a Phillips screwdriver.
Do not over-tighten.
• Lift the pretend buckles on a saddlebag to open the
saddlebag.
• Fit the tab on the back surface of the saddle bag into the
notch on one side of the rear fender.
• Insert three #8 x 3 /
4
" screws through the holes on the
inside of the saddlebag.
Note: The lower screw inserts through holes in the
saddlebag and vehicle body, and then attaches to the
vehicle frame. Make sure all the screw holes are aligned.
18
Saddlebag
Tab
Notch
19
Back View
15
.437 (Large
Diameter)
Cap Nut
Tube
Side
Wheel
Axle
17
• Slide an axle bushing (tube side first) onto the end of
the wheel axle. Make sure the flat end of the axle
bushing fits into the groove in the fork arm.
• Fit a .437 (large diameter) cap nut on the end of
the wheel axle.
• Support the opposite end of the wheel axle and tap the
.437 cap nut with a hammer to secure it on the end of
the wheel axle.
• Pull on the .437 cap nut to make sure the rear wheel
assembly is secure.
Back View
Axle
Bushing
• Tighten the screws using a Phillips screwdriver.
Do not over-tighten.
• Repeat this step to assemble the other saddlebag to the
other side of the rear fender.
73218pr-0920.qrk 5/21/01 2:29 PM Page 15