Harley-Davidson FISHER-PRICE 73218 - Manual (Page 13)

Assembly
13
TM
11
Right
Exhaust
Pipe
TM
10
Right Exhaust
Pipe - Outer Half
• Fit the outer half of the right exhaust pipe (R) to the
inner half of the right exhaust pipe.
Hint: Use a long-shafted screwdriver to complete this
assembly step.
• Align the holes in the inner half of the right exhaust pipe
with the holes in the vehicle frame.
• Insert four #8 x 3 /
4
" screws through the inner half of the
right exhaust pipe and into the vehicle frame.
TM
9
Vehicle
Frame
Right Exhaust
Pipe - Inner Half
*
• Separate the exhaust set pieces. Note the R (right side)
and L (left side) markings on the inside of each piece.
• Fit the inner half of the right exhaust pipe (R) over the
stabilizer wheel on the right side of the vehicle. Make
sure the peg on the inner exhaust pipe fits into the
hole in the vehicle body.
TM
8
Vehicle Frame
(Right Side)
Stabilizer
Wheel
Vehicle
Body Hole
Right Exhaust
Pipe - Inner Half
Peg
• With the holes aligned, insert six #8 x 3 /
4
"screws to join
the two halves of the right exhaust pipe.
• Tighten the screws using a Phillips screwdriver. Do not
over-tighten.
• Repeat steps 8 through 11 to assemble the left exhaust
pipe (L) to the left side of the vehicle.
IMPORTANT! The screw marked with an asterisk * in
step 9 illustration must go through the hole in the inner
half of the right exhaust pipe, the vehicle body and into
the vehicle frame. Make sure all the holes are properly
aligned and the screw goes through all three parts.
• Tighten the screws using a Phillips screwdriver.
Do not over-tighten.
73218pr-0920.qrk 5/21/01 2:29 PM Page 13