HP 3500YL - Manual (Page 369)

Virtual Router Redundancy Protocol (VRRP)
Displaying VRRP Configuration and Statistics Data
VRRP Statistics Data
All command outputs shown in this section assume that VRRP is enabled at
the global configuration level. If global VRRP is disabled, these commands
produce the following output:
VRRP Global Statistics Information
VRRP Enabled : No
Figure 6-13. Statistics Command Output If Global VRRP Is Disabled
Displaying Global VRRP Statistics Only
Syntax: show vrrp statistics global
Displays the global VRRP statistics for the router.
■ VRRP Enabled
■ Protocol Version: 2
■ Invalid VRID Pkts Rx: VRRP packets received for a
VRID that is not configured on the specific VLAN of
the VRRP router.
■ Checksum Error Pkts Rx: VRRP packets received with
a bad checksum
■ Bad Version Pkts Rx: VRRP advertisement packets
received with a version number other than 2.
ProCurve(config)# show vrrp statistics global
VRRP Global Statistics Information
VRRP Enabled : Yes
Protocol Version : 2
Invalid VRID Pkts Rx : 0
Checksum Error Pkts Rx : 0
Bad Version Pkts Rx : 0
Figure 6-14. Example of a Global VRRP Statistics Output
6-39