HP BC1500 - Manual (Page 4)

HP BladeSystem PC Blade Enclosure (sold separately) HP BladeSystem PC Blade Enclosure (sold separately) HP BladeSystem PC Blade Enclosure (sold separately) HP BladeSystem PC Blade Enclosure (sold separately)
Rack Capability Rack Capability Rack Capability Rack Capability Includes the HP BladeSystem PC Blade Switch pre-installed within the enclosure. Mounts in HP 10000
and 9000 series, HP System-E, as well as third-party, and Telco racks. Rack mounting hardware for HP
and third-party racks ships standard with each blade enclosure. Telco rack-mounting hardware is a
separately available option kit.
Rack Airflow Rack Airflow Rack Airflow Rack Airflow
Requirements
Requirements Requirements Requirements
The HP 10000 Series Racks provide enhanced airflow for maximum cooling, allowing these racks to be
fully loaded with blade PCs using the latest processors.
CAUTION: CAUTION: CAUTION: CAUTION: If a third-party rack is used, observe the following additional requirements to ensure
adequate airflow and to prevent damage to the equipment:
Front and rear doors: If your 42U rack includes closing front and rear doors, you must allow
5,350 square cm (830 square inches) of hole evenly distributed from top to bottom to permit
adequate airflow (equivalent to the required 64 percent open area for ventilation).
Side: The clearance between the installed rack component and the side panels of the rack must be
a minimum of 7 cm (2.75 inches).
CAUTION: CAUTION: CAUTION: CAUTION: Always use blanking panels to fill all remaining empty front panel U-spaces in the rack. This
arrangement ensures proper airflow. Using a rack without blanking panels results in improper cooling
that can lead to thermal damage.
NOTE:
NOTE: NOTE: NOTE: Please consult the Setup & Installation Guide for the blade PC for additional details.
Enclosure Includes Enclosure Includes Enclosure Includes Enclosure Includes Pre-installed HP BladeSystem PC Blade Switch
3U high rack-mountable chassis with 20 blade PC bays
Rack mounting hardware for HP, Compaq-branded and third-party racks
Rear bay for HP BladeSytem PC Blade Switch (included) for network cable management
ProLiant Essentials Foundation Pack licenses for 20 Blade PCs (see features following)
Four hot-plug fans
Dual hot-plug power supplies (600 watts each), power cords
Diagnostic Adapter Diagnostic Adapter Diagnostic Adapter Diagnostic Adapter
Interfaces
Interfaces Interfaces Interfaces
NOTE: NOTE: NOTE: NOTE: Enclosure/Blade PC Diagnostic adapter and graphics cards sold separately
Blade PC LEDs (6)
PS/2 Mouse
PS/2 Keyboard
VGA monitor (functional only when graphics diagnostics card installed)
Serial RS-232 port
USB 2.0
QuickSpecs
HP BladeSystem bc1500 Blade PC HP BladeSystem bc1500 Blade PC HP BladeSystem bc1500 Blade PC HP BladeSystem bc1500 Blade PC
Standard Features
DA - 12390 North America — Version 4 — January 22, 2007 Page 4