Hoshizaki DM-200B - Manual (Page 7)

7
C. Setup
IMPORTANT
It is extremely important that the dispenser be leveled in both the left-to-right
and front-to-rear directions. If it is not level, a reduced rate of ice flow may
result.
1) Unpack the dispenser, and remove the shipping carton and all tape and packing
material before operating the unit. Attach the four (4) (optional) adjustable legs to the
bottom of the dispenser. The legs are adjustable from a minimum of 4 inches (102 mm)
to a maximum of 5 inches (127 mm). Be careful not to damage the exterior panels
when handling the dispenser.
2) Position the dispenser in the selected site. Clean and wipe the interior with a clean
cloth.
3) Level the dispenser in both the left-to-right and the front-to-rear directions (when
installed with or without legs).
4) When installing the unit without legs, the perimeter where the machine touches the
counter should be sealed with silicone to prevent water from collecting under the
dispenser. The right side panel should be removed prior to applying the silicone so that
it can be easily removed later if drive mechanism inspection and/or service becomes
necessary.
D. Electrical Connection
CAUTION
The GREEN ground wire in the factory-installed power cord is connected to a
screw on the frame. If it becomes necessary to remove or replace the power
cord, be sure to connect the power cord's ground wire to this screw upon
reattachment.
This dispenser requires a proper electrical ground that meets the national and local
electrical code requirements. Plug it into a 115 volt, 15 amp outlet with a ground connection
(115V/15 Amp/60Hz). Refer to the nameplate for the proper electrical specifications.