Hi-Touch Imaging Technologies Mug Heat Press Kit - Manual (Page 14)

Chapter 3 Mug Heat Press
Standard Operation Procedure
1. You should have the following tools in hand: Mug Heat Press, Bubble
Eliminator, White Ceramic Mug, Mug Locating Tape, Dye Sublimation
Photograph, Mug Locating Coil, Clean Towel (recommend polyester
fabric),a pair of gloves and a bottle of methane,
2. Pour an equivalent of 1 teaspoon of methane into the polyester fabric.
Carefully wipe the surface and remove any dirt or dust from the white
ceramic mug.
Useful Tips:
(1). Use only the photograph that is just been printed out for mug imprint!
(2). Gently remove any dust from photograph and ceramic mug.
(3). Use methane to clean the surface to avoid any dust been left out.
(4). Avoid direct finger contact with mug and photograph surface.
3. Place the white ceramic mug into the mug locating coil. Align the mug
holder with the mug locating coil as illustrated below,
The zero of locating coil