Hatco GLO-RAY GRN - Manual (Page 21)

Form No. GRM-0707 19
INSTALLATION
OPERATION
Figure 23. Remote Control Box (RMB)
(RMB-7 Series Shown)
CAUTION
Some exterior surfaces on the unit will get hot.
Use caution when touching these areas to avoid
injury.
WARNING
The unit is not waterproof. DO NOT submerge in
water. Do not operate if it has been submerged
in water.
CAUTION
Standard and approved manufacturing oils will
smoke up to 30 minutes during initial start-up.
This is a temporary condition. To assure safe
operation, operate unit without food product
until smoke dissipates.
Heating Element(s)
Heating element(s) are controlled by an ON/OFF
toggle switch(es) or an optional infinite switch(es).
To turn each element on, either flip the toggle switch
to the ON position or turn the adjustable switch to
the desired setting.
Allow 15-20 minutes to reach operating
temperature.
NOTE: Remote control enclosures are
recommended for all Glo-Ray units.
Optional Infinite Control
Toggle Switch (On/Off)
Indicator Light
Remote Mounted Control Box (RMB)
Hatco Remote Mounted Control Boxes include
switches, wire leads and/or indicator lights and are
ready for installation. Proper use of RMB’s require
one RMB per strip heater.
NOTICE
To prevent premature failure to components the
Remote Control Box (RMB) must be installed
outside the foodwarmer heat zone.
Control Switches
When two or more units are mounted where the
heat from one housing tends to raise the
temperature of another, the control switches should
be installed in a remote control enclosure. Units in a
multiple installation should use remote control
enclosures.
NOTE: Remote control enclosures are available in
five sizes. All models are built in accordance with
U.L. standards to accommodate switches, indicator
lights and wiring, ready for installation. See
ACCESSORIES at the back of this manual.
Lights
On models equipped with lights, flip the toggle
switch to the ON position to energize the lights.
NOTE: Dual Glo-Ray units do not use a built-in
infinite switch.