HP C6100 - Manual (Page 15)

HP All-in-One • 15
Basics Guide
HP Photosmart C6100 All-in-One series
?
Network Troubleshooting
Problem: The Printer Not Found message appears.
Action: First make sure that you have an active connection with the HP All-in-One.
Check your color graphics display for an icon. If you do not see an icon, go back
to your connection type Section (B or C).
If you have an active connection, try the following:
• Turn the HP All-in-One off, wait 30 seconds, and then turn it back on.
• Try temporarily disconnecting your fi rewall.
Wired (Ethernet) network users:
• Check the cable between the router and the HP All-in-One.
• Check the cable between your computer and the HP All-in-One.
• Make sure your LAN card is set up properly.
See the Basics Guide for more troubleshooting and additional set up information.
Problem: You are not sure if your network is set up properly.
Action: For information on how to set up a network, go to www.hp.com/support .
Enter Photosmart C6100 , and then search for Network Setup .
Problem: You are trying to set up a wireless connection through the control panel, and the HP All-in-One
does not connect to the network.
Action:
• On the wireless router, turn on broadcast network name options, and turn off silent broadcast name.
• Move the wireless router closer to the HP All-in-One and make sure there are no obstructions.
• Turn the wireless router off, wait 30 seconds, and then on again.
• Make sure you entered the correct wireless communication mode and authentication type. See steps C1
through C3 .
• See the Basics Guide for more details and troubleshooting information.
Problem: I have SecureEasySetup, but when I ran the Wireless Setup Wizard, a list of available networks
appeared or the Select Network Name screen appeared.
Action: It is likely that you ran out of time after putting the wireless router in SecureEasySetup mode. Put your
wireless router into SecureEasySetup mode again, and then rerun the Wireless Setup Wizard.
Problem: An invalid WEP key or WPA passphrase. This problem could be caused by typing incorrectly, by
changing the case of the key or passphrase or by inserting blank spaces at the beginning or end.
Action: Rerun the Wireless Setup Wizard, and type in the WEP key or WPA passphrase correctly, making sure
there are no blank spaces at beginning or end.