Holux GM-305 - Manual (Page 28)

28
(iii) Please refer to Waypoints in page 22 for editing.
(iv) When complete, move marked field to“ˇ” and press “ ” to return to previous page.
Then press ” ” to return to former page.
D. Delete a Route
(i) Go to the page as Fig. 5-2-1 or select from Main MENU.
(ii) Select the route to be deleted.
(iii) Press “ ”
.
(iv) Select Delete and press “ ” to erase the route.
(v) Press ” ” when complete.
Note! (a) The route can not be deleted if a navigation route existing. Be sure to cancel
navigation before deleting.
(b) The name of deleted waypoint and route will not appear again in the system unless
you edit it and name it again.
E. Delete All Routes
The same as above, select Delete All.
F. Set Navigation
(i) Go to the page as Fig. 5-2-1 or select from Main MENU.
(ii) Select the route to be navigated.
(iii) Press “ ”, Select Set Navi and press “ ”. A mark of “＊” will show at right side of
the route.
(iv) Press “ ” to return to the former page. The selected route will link all waypoints created
and show in the map screen.
G. Cancel Navigation
(i) Go to the page as Fig. 5-2-1 or select from Main MENU.
(ii) Press “ ”, Select Cancel Navi and press “
”.
III. TRACK LOGS
Explorer can hold up to 6 tracks, 5 in back up and 1 in use.
Select Track Logs from Main Menu and press “ ” to the page as follows:
Off: Stop recording track logs
Fill: Recording Track log until
memory full (up to 2,500 points)
Wrap:Endlessly recordingTrack log.
2: total track logs saved.
5: total track logs back up
available in the system.
ON: Display Track
logs in Map.
Off: No display in map.
Memory space occupied
(by current recording track)
Fig. 5-3-1