Figure 2-26, Display monitor menu, Configuring – Honeywell HREP4 User Manual
Page 42: The display sequence, Configuring the display sequence
42
Installation
Figure 2-26
DISPLAY MONITOR Menu
Use the
to change the following values:
Configuring the Display Sequence
Click SEQUENCE on the left side of the DISPLAY window. The SEQUENCE menu appears.
SEQUENCE DWELL
Choose how long each screen is displayed in a
sequence.
SPOT DWELL
Choose how long each screen is displayed on the
spot monitor outputs.
DE-INTERLACED MODE
Set to ON when recording any channels in D1
resolution (704x576) to prevent shudder during
playback.
ALARM POP-UP MODE
Set to ON so that the associated channel displays in
full screen when an alarm is triggered.
ALARM POP-UP DWELL
Choose how long the full-screen popup displays
after an alarm is triggered. If the alarm condition
continues, then the popup screen displays
constantly.
MOTION POP-UP MODE
When set to ON, motion detection causes the
associated channel to display full screen.
MOTION POP-UP DWELL
Choose how long the full-screen popup displays
after motion detection. If motion continues, the
popup screen displays constantly.