Table 2-4, Configurations for continuous/motion recording – Honeywell HREP4 User Manual
Page 67
HREP Color Digital Video Recorder User Guide
Document 800-06847 Rev B
67
08/10
3. Configure the SIZE, FPS, QUALITY, and AUDIO for each channel. Click
to save a
setting. Click
to cancel a setting and exit that setting.
4. Select OK, then press
to save your settings. Press
or navigate to CANCEL
then press
to exit without saving the changes.
When configuring 16 channels, the channels are divided into two groups of 8.
Note
The maximum recording frame rate for each group is 240FPS at a resolution
of 1 CIF (352x240).
Four channels can be recorded in full D1 (4CIF@704x480) resolution, with a maximum of 2
two channels from each group.
Note
Remember that if the SCHEDULE MODE is set to WEEKLY, then the
recording settings should be changed for each day as well as for each
particular time.
Note
This DVR supports a maximum recording rate across all channels of 480
frames per second at 352x240 resolution. As the settings are adjusted, the
“frames available” at the bottom left displays the number of available frames
still remaining and must always be zero or higher. See
.
If, while changing recording settings, this figure becomes negative, then the
recording resolutions and/or frame rates must be lowered to increase the
“frames available” value to zero or above.
Table 2-4
Configurations for Continuous/Motion Recording
Configuration
Description
SIZE
Select recording resolutions of 352x240, 704x240, or 704x460
(NTSC) can be selected for each channel.
FPS
Frame rates between 1 and 30 can be set for each channel.
QUALITY
Four different picture recording qualities can be set for each
channel.
AUDIO
If audio devices are connected to the DVR, you can turn the audio
recording ON/OFF. Any audio channel can be assigned to any of
the video channels. Please refer to your camera’s setup menu.
During playback, when a particular channel is selected in full
screen, the assigned audio channel plays back at the same time.