Honeywell HREP4 - Manual (Page 51)

HREP Color Digital Video Recorder User Guide
Document 800-06847 Rev B 51
08/10
4. Select the firmware from the firmware list, then click UPGRADE.
The firmware upgrade begins.
Configuring for Controlling DVRs
You can configure your system to control up to 254 DVRs from the same keyboard.
1. Click CONTROL DEVICE on the left side of the SYSTEM window.
The CONTROL DEVICE menu appears.
Figure 2-42 CONTROL DEVICE Menu
2. Use the to configure the following settings:
Configuring the Users
Select USER in the Main system setup window, then click . The USER setup window
opens.
FACTORY DEFAULT Use to restore factory default settings.
SYSTEM DATA System settings can be saved to a USB memory stick. The
settings can be reloaded in case of accidental factory
default or can be transferred to another DVR if multiple
units need to be installed with the same settings. All
information is saved apart from the network settings and
the system name.
PASSWORD Activates/deactivates the need for a password to enter
specific menus
SYSTEM ID If more than one DVR is connected on the same RS485 bus, each
one must have a unique ID.
Note If you are using more than one DVR on a stack, then each
DVR must have a unique ID for being controlled by a
remote control.
PROTOCOL Must be set by Control Device.
BAUD RATE Must be set to match the baud rate of the PTZ controller.