Harbor Freight Tools Clear Water Pump 69297 - Manual (Page 6)

Page 6 For technical questions, please call 1-800-444-3353. SKU 69297
troubleshooting
problem possible causes likely Solutions
Motor will
not start.
1. Cord not connected.
2. No power at outlet.
3. Fuse is blown or breaker tripped.
4. Internal damage or wear. (Carbon
brushes or switch, for example.)
1. Check that cord is plugged in.
2. Check power at outlet. If outlet is unpowered,
turn off tool and check circuit breaker. If breaker
is tripped, make sure circuit is right capacity
for tool and circuit has no other loads.
3. Turn off and unplug pump, have fuse replaced
by a qualified service technician.
4. Have serviced by a qualified service technician.
Motor runs
but water isn’t
pumping.
1. Improper priming.
2. Clogged filter at end of
intake connections.
3. Discharge valve closed.
4. Pipe size too small.
5. Impeller plugged.
6. Pipes frozen.
1. Re-prime according to directions.
2. Clean filter.
3. Open discharge valve.
4. Re-pipe using pipe of the same size as
the Pump inlet and outlet ports.
5. Have Impeller cleaned by qualified service technician.
6. Thaw pipes. Check for damage before using pump.
Pump does not
deliver water at
full capacity.
1. Corroded pipes.
2. Piping size too small.
3. Not enough water supplied to Pump.
4. Low Voltage.
1. Replace pipes.
2. Re-pipe using pipe of the same size as
the Pump inlet and outlet ports.
3. Enlarge inlet pipe. Check well pump system.
4. Check that outlet is 120V.
Excessive noise
or rattling.
Internal damage or wear. (Carbon
brushes or bearings, for example.)
Have technician service tool.
Follow all safety precautions whenever diagnosing or servicing the tool. disconnect power
supply before service.
pleaSe Read the FolloWinG caReFullY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A
REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTA-
TION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS
TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN
FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS
REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE
BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION
OF REPLACEMENT PARTS THERETO.