Hitachi EC 129 - Manual (Page 10)

— 10 —
English
SPECIFICATIONS
Model EC129
Motor Single-Phase, Induction Motor
Power Source Single-Phase, 120V AC 60Hz
Output Power
2.5 HP
(1.8 KW)
Current 15.0 A
Tank Capacity
5 gal.
(18.9 ltr)
Maximum Pressure
125 PSI
(8.6 bar)
at 40 PSI 6.0 CFM
(2.8 bar) (170 ltr/min)
at 90 PSI 4.7 CFM
(6.2 bar) (133 ltr/min)
at 100 PSI 4.4 CFM
(6.9 bar) (125 ltr/min)
Lubrication Oil
Free Air
Delivery
2. Power switch
Ensure that the knob of the pressure switch is in the
“OFF” position (Fig. 2). If the plug is connected to a
receptacle while the knob is in the “ON” position, the
compressor will start operating immediately and can
cause serious injury.
Fig. 2
3. Extension cord
When the work area is far away from the power
source, use an extension cord of sufficient thickness
and rated capacity (refer page 7). The extension cord
should be kept as short as practicable.
WARNING:
Damaged cord must be replaced or
repaired.
4. Confirm the power receptacle
If the power receptacle only loosely accepts the plug,
the receptacle must be repaired. Contact the nearest
electric store for repair service.
If such a faulty receptacle is used, may cause
overheating, resulting in a serious hazard.
Knob of the pressure switch
ACCESSORY
WARNING:
Accessory other than these shown
below can lead to malfunction and
resulting injuries.
STANDARD ACCESSORY
Dipstick ............................... 1
APPLICATIONS
⅜ Air source of the pneumatic nailer and stapler.
WARNING:
Never use compressor for
applications other than compressor
for pneumatic nailer and stapler.
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power source requirements specified on the
product nameplate.
e_ec129_e.p65 4/8/04, 5:38 PM 10