Heath Zenith Wireless Push Button Accessory 598-1105-06 - Manual (Page 2)

-2- 598-1105-06
1. Remove back of push button. To remove
back of push button, push in tab on bottom with
a small screwdriver. Pull battery tab to activate
factory installed batteries.
2. Set the push button dip switches to match
the chime receiver code. See Code and Tune
Setting section.
3. Test range. Temporarily position push button where you want it
mounted. Press push button to verify chime and push button work
properly. If chime does not sound, see Troubleshooting.
4. Mount push button. Use either screws or double sided tape to mount
push button.
• To mount with screws, remove back of case by pushing in tab on
bottom with a small screwdriver. Remove material in screw hole.
Attach back of case to door jamb or wall with screws provided. Snap
front of push button on.
• When attaching push button using double sided tape, make sure
the surface of the door jamb or wall is clean.
This End
Up
Remove material in
screw hole before
mounting with
screws
Pull tab to activate
batteries