HP 2045 - Manual (Page 26)

Sample Print/Locked Print
20
3
Form Feed
This section gives instructions on op-
eration when the machine does not
have a tray for the selected paper size
or type, or when paper loaded in the
machine has run out.
Limitation
❒ The tray cannot be changed if the
following functions are set for it.
• Staple
• Punch
• Duplex Print to a tray that does
not support duplex printing
• Cover Sheet
• Front/Back Covers
• Slip Sheets
• Chaptering
• Chapter Slip Sheets
Note
❒ If form feed is selected for a tray
with the following settings, you
can change the tray by canceling
the settings:
• Staple
• Punch
❒ If Auto Continue is selected, the
form feed paper is printed after a
set interval. See p.39 “System”.
If the machine does not have a tray for
the selected paper size or paper type,
or if the selected paper loaded in the
machine has run out, a caution mes-
sage appears.
If this message appears, do one of the
following.
Print using a selected tray
AAAA
Select the tray for form feed from
those that appear on the control
panel.
If you want to print after adding
paper to the tray, select the tray af-
ter loading the correct paper.
Note
❒ To load paper in the bypass tray,
see "Setting Paper on the Bypass
Tray", Printer Reference 1.
BBBB
Press [OK].
The machine prints using the se-
lected tray.
Note
❒ If a tray with a small paper size
is selected, the print job may be
cut short, or other problems
may occur.
Canceling the form feed
AAAA
Press [Job Reset].
Delete the stored print job, and
then cancel form feed.