HP 2045 User Manual
Page 29
Error & Status Messages on the Display Panel
23
4
Following output tray is full.
### Remove the paper. ###
The indicated output tray is
full.
Note
❒ “###” in the message rep-
resents a output tray.
Remove the paper.
HDD has a problem.
An error has occurred in the
hard disk drive.
Turn off the main power
switch, and on. If the message
appears again, contact your
sales or service representative.
HDD has not been installed.
The Locked Print was per-
formed without the hard disk
installed, or the hard disk is
damaged.
Contact your sales or service
representative.
HDD is full.
The maximum hard disk area
size for form/font has been ex-
ceeded.
Delete unused form /font
types.
An HDD overflow error oc-
curred during Sample Print or
Locked Print.
Delete stored files or reduce
the file to be downloaded.
IEEE 802.11b (Wireless LAN)
has a problem.
IEEE 802.11b card was not in-
serted when the machine was
turned on, or it was pulled out
after the machine turned on.
Turn off the machine and
check the IEEE 802.11b card is
inserted correctly. Then, turn
on the machine again. If the
message appears again, call
your service center.
LCT has a problem. Turn
Main Power Switch off then
on. If the error appears again,
call service representative.
An error occurred in the large
capacity tray.
Turn off the main power
switch, wait five minutes, and
on again. If the message ap-
pears again, call your sales or
service representative.
dLower Staple is almost
empty.
There are a few staples re-
maining in the lower stapler.
Load in more staples.
NV-RAM has a problem.
An error has occurred in the
optional memory unit.
Turn off the main power
switch, and on. If the message
appears again, call your sales
or service representative.
Output tray has been
changed.
The output tray has been
changed automatically.
Select the proper output tray.
Paper in duplex unit. Open
cover and remove paper.
There is a misfeed in the du-
plex unit.
Open the cover of the duplex
unit, and remove the misfed
paper.
Paper in staple tray. Open fin-
isher cover and remove pa-
per.
There is paper remaining in-
side the finisher.
Open the cover of finisher, and
remove the paper.
Messages/Second messages
Description
Solution