HP 2045 - Manual (Page 57)

Punch
51
6
Precautions when punching
Limitation
❒ Punching cannot be done when paper is fed from the bypass tray.
Note
❒ If you cannot make punch settings even with the finisher installed, options
may not be set correctly in the printer driver. Correct option settings in the
printer driver. For details, see the printer driver Help.
❒ When duplex printing is selected, adjust punch positions to the binding ori-
entation.
❒ Be sure to set the punch position same as the staple position when using it to-
gether with the staple function.
❒ Be sure to set paper size and orientation in the printer driver when punching.
• Depending on the software you are using, print settings may not be en-
abled and the printed result may not be as expected.
❒ Punch will be cancelled under the following conditions:
• When a paper size that cannot be punched is selected. For information
about paper sizes that can be punched, see “Specification”, General Settings
Guide.
• When a paper type that cannot be punched is selected. OHP transparencies
cannot be punched.
• If positions other than those fixed for punching are specified.
• If there are inconsistencies between the duplex folding section and the
punch position during duplex printing.
• When feeding paper from the bypass tray.
• When the punch receptacle has become full and when Auto Continue has
been set, printing will continue without punching after the message has
been displayed.