Before you begin, Assembly step you’re finished, Location of the bike – Horizon Fitness B701 User Manual
Page 7: Adjusting levelers
BEFORE
YOU
BEGIN
12
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
BIKE
OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE YOU
BEGIN
ASSEMBL
Y
1
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
BIKE
OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
BEFORE YOU
BEGIN
ASSEMBL
Y
ASSEMBLY STEP
YOU’RE FINISHED!
A
004721-00
Z01
005145-A
Z02
B
C
004755-00
Z06
E
004382-00
Z07
F
005165-00
Z04
G
004733-00
Z05
BOLTS (J)
CONSOLE MAST
CONSOLE
WATER BOTTLE
HOLDER
CONSOLE WIRES
WIRES
BOLT (J)
12 mm
Qty: 4
BOLT (J)
12 mm
Qty: 4
HARDWARE BAG CONTENTS:
BEFORE YOU BEGIN
CONGRATULATIONS!
on choosing your bike. You’ve taken an important step in developing and
sustaining an exercise program! Your bike is a tremendously effective tool for achieving your personal
fitness goals. Regular use of your bike can improve the quality of your life in so many ways.
HERE ARE jUST A FEW OF THE HEALTH BENEFITS OF ExERCISE:
• Weight Loss
• A Healthier Heart
• Improved Muscle Tone
• Increased Daily Energy Levels
The key to reaping these benefits is to develop an exercise habit. Your new bike will help you eliminate
obstacles that prevent you from exercising. Inclement weather and darkness won't interfere with your
workout when you use your bike in the comfort of your home. This guide provides you with basic information
for using and enjoying your new machine.
LOCATION OF THE BIKE
Place the bike on a level surface. Do not place the bike in any area that will block any vent or air openings.
The bike should not be located in a garage, covered patio, near water or outdoors.
ADJUSTING LEVELERS
Adjust the 4 front and rear levelers so that the bike is level on the floor. Then adjust the center leveler
located under the MAIN FRAME TUBE just so it is snug with the floor.
REAR LEVELERS
CENTER LEVELER
FRONT LEVELERS
Open
HArDWAre BAG 5.
Attach the
CONSOLe WireS to the WireS running through the CONSOLe mAST as shown in illustration.
Discard
rOUTiNG Wire when finished.
Attach the
CONSOLe to the CONSOLe mAST using 4 BOLTS (J), as shown in illustration.
NOTe: Do not pinch wires.
Slide
WATer BOTTLe HOLDer onto backside of CONSOLe.
Connect AC ADAPTOR to the AC ADAPTOR INPUT, located at front of the main frame. Connect ADAPTOR to a
power outlet.
A
B
C
D
ASSEMBLY STEP :
B701_Rev.1.4.indd 12-13
7/29/08 9:21:38 AM