HONDA AUTOMATIC DAY/NIGHT MIRROR (ATTACHMENT KIT) - Manual (Page 10)

10 of 10
AII 30556 (0509) © 2005 American Honda Motor Co., Inc. - All Rights Reserved.
44. Under the dashboard, secure the day/night mirror
harness to the vehicle harness with three wire
ties.
45. Check that all wire harnesses are routed properly
and all connectors are plugged in.
46. Reinstall the driver’s side seat, torque the driver’s
seat bolts to 32 to 38 N·m (24 to 28 lb·ft)
47. Reinstall all removed parts. Check that all clips
and other fasteners are installed securely.
48. Reconnect the negative cable to the battery.
49. Set the clock, and reset the radio station presets.
50. Check the operation of the automatic day/night
mirror according to the Owner’s Manual supplied.
NOTE: Whenever the battery is disconnected, the
driver’s AUTO function is disabled.
51. Start the engine. Push down on the driver’s
window switch until the window is fully open.
52. Pull up on the driver’s window switch fully to close
the window completely, then hold the switch for 2
seconds.
53. Test the driver’s window AUTO function.
4202051H
DAY/NIGHT
MIRROR
HARNESS
VEHICLE
HARNESS
WIRE TIE
42. Secure the day/night mirror harness to the vehicle
harness with four wire ties.
4202032H
WIRE TIE
DAY/
NIGHT
MIRROR
HARNESS
WIRE TIE
VEHICLE
HARNESS
43. Secure the day/night mirror harness to the vehicle
harness with three wire ties.
4202040H
DAY/NIGHT MIRROR
HARNESS
VEHICLE
HARNESS
WIRE TIE