Harmar Mobility LIFTS RPL400 - Manual (Page 9)

Anchoring the Lift
Step 1
• Position the lift in its final location.
• Verify that it is level and perpendicular to its
surroundings.
• Shim if necessary.
Anchors
Harmar recommends securing the lift using
our Anchor Kit. If you purchase you own floor
anchors they must use 1/2-13 bolts and have
a minimum tensile strength of 6000 LBS.
Warning: All four floor anchors
must be installed correctly in
accordance to
their instructions.
Step 2
Use the lift’s base as a template. Drill 4 holes
into the concrete.
Verify that the holes you have drilled are
deep enough to accept the anchors.
Tip: Concrete dust may have settled into
the holes you just drilled. Use a shop
vacuum to clean out these holes. This will
ensure the floor anchors set correctly.
Step 3
Secure the lift in place by tightening the floor
anchor bolts.
9