Holman qt14 User Manual
Page 13
IF FURTHER ASSISTANCE IS REQUIRED:
CONTACT STAR/HOLMAN FACTORY SERVICE TEAM AT 1-800-807-9054
11
3.
Clean air intake on the side of Sandwich Warmer by vacuuming any dust and debris built up on fan
grill.
4.
Return unit to counter and remove screw holding power supply side panel in place. Carefully lift panel
up and out. Two ground straps hold panel to oven chassis. DO NOT REMOVE GROUND STRAPS
OR DISCONNECT POWER SUPPLY CORD. Vacuum any dust and debris from inside of unit
(repeat for opposite side).
5.
Replace all panels when done. CHECK THAT ALL WIRES DO NOT GET PINCHED AS THE
PANELS ARE REPLACED. ALSO CHECK ANY WIRES AROUND THE MOTOR TO MAKE SURE
THEY DO NOT GET PUSHED INTO THE SPROCKETS. Mounting screws for panels should be
started by hand, and then tightened with a screwdriver.
6.
For exterior portions of unit that are heavily soiled, an abrasive pad may be used for cleaning. Be
sure to pass the pad in the direction of the grain in the metal to maintain the surface’s finish. Lightly
soiled surfaces may be cleaned with a damp cloth and mild cleaner.
7.
Reconnect unit to power supply and test for proper operation.