Hitachi CM650ET - Manual (Page 10)

Install the monitor in the following way, taking care to maintain safety
FRONT VIEW
Control Panel
Tilt Swivel Base
Rear Cover
Signal Input
Connector
AC Inlet
Power Cord
REAR VIEW
USB Slot to a receptacle of to the host computer
(for the optional USB HUB Module) the correct voltage
1. Installation
Install the monitor on a horizontal base.
2. Power Cord Connection
Make sure of using the power cord meeting the safety standard of the country in
which you are using the monitor.
Insert the connector of a power cord to the AC Inlet of the monitor.
Insert the plug of the power cord to a power point of the correct voltage.
3. Signal Cable Connection
Insert the Signal Input Connector of the monitor to the host computer, with attention to
it’s suitability, and secure the screws on the connector shell firmly.
D-Sub Mini 1 B-pin Connector
4. Power On
Turn on the Power Switch of the
monitor first, then the computer.
Refer to Page 1-8 “POWER ON/OFF”.
Pin No. Signal
1 Red Video
11 Ground
12 Bi-directional Data [SDA]
13 (or
14
15 Data Clock [SCL]
l - 6