Hitachi CM650ET User Manual
Page 9
n
FOR THE CUSTOMERS IN THE U.K.
THIS PRODUCT IS SUPPLIED WITH A TWO PIN MAINS PLUG FOR USE IN MAINLAND
EUROPE.
FOR THE U.K. PLEASE REFER TO THE NOTES ON THIS PAGE.
IMPORTANT FOR UNITED KINGDOM
WORDING FOR CLASS I EQUIPMENT INSTRUCTION BOOKS AND LABELS
The mains lead on this equipment
is supplied with a moulded plug incorporating a fuse,
the value of
which is indicated on the pin face of the plug.
Should the fuse need to be
replaced, an ASTA or BSI approved BS 1362 fuse must be used of
the same rating.
If
the fuse cover is detachable never use the plug with the cover omitted.
If a replacement
fuse cover is required, ensure it is of the same
as that visible on the pin face of the
plug.
Fuse covers are available from your dealer.
DO NOT cut off the mains plug from this equipment.
If the plug fitted is not suitable for
the power points in your home or the cable is too short to reach a power point, then
obtain an appropriate safety approved extension lead or consult your dealer.
Should it be necessary to change the mains plugs, this must be carried out by a
competent person, preferably a qualified electrician.
If there is no alternative to cutting off the mains plug, ensure that you dispose of it
immediately, having first removed the fuse, to avoid a possible shock hazard by
inadvertent connection to the mains supply.
WARNING: THIS EQUIPMENT MUST BE EARTHED
IMPORTANT
The wires in the mains lead are coloured in accordance with the following code:
Green Yellow
to Earth
Brown to Live
Fuse
Blue to Neutral
Cord Clamp
Green and Yellow = Earth, Blue = Neutral, Brown = Live.
As these
may not correspond with the coloured markings identifying the
terminals in your plug, proceed as follows:
The wire which is coloured GREEN and YELLOW must be connected to the terminal in
the plug which is marked with the letter E or by the earth symbol
or coloured GREEN
or GREEN and YELLOW.
The wire coloured BLUE must be connected to the terminal marked with the letter N or
coloured BLUE or BLACK. The wire coloured BROWN must be connected to the
terminal marked with the letter L or coloured BROWN or RED.