Hitachi CM650ET - Manual (Page 12)

Power LED Power Switch
Switches Switches Switch
POWER
Press the Power switch, to switch the power ON or OFF.
n When power is ON, the power LED lights.
n After turning OFF the switch, wait at least 5 seconds before restarting the monitor.
Otherwise the monitor may operate incorrectly.
If the picture doesn’t appear, turn OFF the power switch, make sure of the following
and wait at least 30 seconds before restarting the monitor.
Make sure the power switch of the computer, power cord connection, signal cable
connection and the input sync. signal are correct.
CONTROL
Press the Status switch. The On Screen Display function of then shows
the selected function, its condition, the function menu and the input signal
frequencies.
n You can select the language.
Use the function “LANGUAGE SELECT”.
To select the function, use the Function
switches.
To execute the selected function, use the
Adjust Switches in the Table-l overleaf.
n You can save the your geometry and
settings. Refer to “SAVE” below.
. . .
Sample of
n To clear the
either push the status
switch again or wait for 10 seconds.
SAVE
If the function “AUTO SAVE” is ON, you can save automatically at clearing the
l - 8