Harbor Freight Tools CENTRAL MACHINERY 98524 - Manual (Page 8)

SKU 98524 For technical questions, please call 1-800-444-3353. Page 8
SPECIFICATIONS
Electrical Requirements 120 V~ / 60 Hz / 15 A
Motor (Cutter head)
Speed
8,000 RPM, 16,000
cuts per minute
Maximum Cutting Depth 3/32”
Stock Capacity
13” W x 6” H
Cutting Blades Two 13-1/8” L
Feed Speed 23 Feet per Minute
Dust Port Opening 2-3/16” I.D.
Included Accessories
1 Hex Wrench (4mm)
2 Magnets
1 Dust Bag
UNPACKINg
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
INSTRUCTIONS FOR
PUTTINg INTO USE
Read the ENTIRE ImPORTANT
SAFETY INFORmATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
TO PREVENT
SERIOUS INjURY
FROm ACCIDENTAL
OPERATION:
Turn the Power Switch of the
tool to its “OFF” position and
unplug the tool from its
electrical outlet before
assembling or making any
adjustments to the tool.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Assembly
Select an area with enough room to 1.
fit the chosen dust collection system.
Select a workbench to mount the
Planer. Place the Planer on a work-
bench able to support the weight of
the Planer and the wood stock being
planed. The orientation of the Planer
should enable the easy entry and exit
of long pieces of wood stock.
Using a pencil, mark through the
2.
mounting holes of the Planer, onto
the workbench. Slide the Planer
aside and drill four 3/8 inch mounting
holes into the workbench.
Before drill-
ing, verify that there are no utility
wires or other obstructions under
the workbench.
Slide the Planer back over the mount-
3.
ing holes in the workbench, and se-
cure the Planer to the workbench with
bolts, washers, spring washers and
nuts (not included). Securely tighten.
Handle (4)
Head
Screw (1)