Connect to additional computers on a network, Manage your network settings, View and print network settings – HP 2570 User Manual

Page 36

Advertising
background image

6.

Follow the onscreen instructions to complete all the installation steps, including
the

Setup Assistant

.

When you have finished installing the software, your HP All-in-One is ready for
service.

7.

To test your network connection, go to your computer and print a self-test report
to your HP All-in-One. For more information, see

Print a self-test report

.

Connect to additional computers on a network

If you have additional computers on the same network as the HP All-in-One, you can
use the additional computers with your HP All-in-One after you have installed the HP
software on each computer. For more information, see

Install the software for a

network connection

. Once you have set up your HP All-in-One on the network you will

not need to configure it again when you add additional computers.

Change the HP All-in-One from a USB connection to a
network connection

If you first install your HP All-in-One with a USB connection, you can later change to
an Ethernet network connection. If you already understand how to connect to a
network, you can use the general directions below. For more detailed instructions on
connecting a HP All-in-One to a network, see

Wired network setup

.

To change a USB connection to a wired (Ethernet) connection
1.

Unplug the USB connection from the back of your HP All-in-One.

2.

Connect an Ethernet cable from the Ethernet port on the back of the HP All-in-
One to an available Ethernet port on the router, switch, or wireless router.

3.

Run the installation CD, choose

Add a Device

, then choose

Through the

network

. For more information, see

Install the software for a network connection

.

4.

(Windows only) When the installation is complete, open

Printers and Faxes

in

the

Control Panel

and delete the printers from the previous USB installation.

Manage your network settings

You can manage network settings for the HP All-in-One through the HP All-in-One
control panel as described in the next section. Additional advanced settings are
available in the Embedded Web Server, a configuration and status tool you access
from your Web browser using an existing network connection to the HP All-in-One.
For more information, see

Use the Embedded Web Server

.

Change basic network settings from the control panel

The HP All-in-One control panel enables you to perform a variety of network
management tasks. This includes viewing the network settings, restoring the network
defaults, and changing the network settings.

User Guide

33

Network setup

Advertising
This manual is related to the following products: