Hitachi SBW100 - Manual (Page 8)

Controls and Functions
Front Panel Controls / LED Indicators
Rear Panel of Subwoofer
Rear Panel of Soundbar
The controls and functions of the SBW100 and the Remote Control are explained below.
REMOTE CONTROL Sensor
Point your remote control at this area when you use the
remote control.
POWER ON Indicator
Plug the power cord into the AC outlet. The Soundbar goes
to the standby mode, and this indicator is also turned off.
Press the POWER button to turn the Soundbar on, this
indicator will illuminate to indicate the Soundbar is on.
This indicator will remain on as long as an input signal is
active. If the input becomes inactive the Soundbar will
change to standby mode to conserve power and this
indicator will turn off.
FX SURROUND (FX) / STEREO (ST) Indicator
The FX indicator lights up when FX Surround is selected.
The ST indicator lights up when Stereo Mode is selected.
This indicator will turn off after about 3 seconds from
selecting the surround setting.
MUTE ON Indicator
This indicator lights up when mute is on.
This indicator will turn off after about 3 seconds from turning
mute on.
MAIN VOLUME / SUBWOOFER VOLUME
Level Indicator
This indicator shows the level of the main volume or
Subwoofer volume when you use the MAIN VOLUME Button
or the SUBWOOFER VOLUME Button respectively.
The indicator will turn off after about 3 seconds from
adjusting the volume.
INPUT SELECTION Indicator
The 1, 2, or 3 indicator lights up when INPUT 1, INPUT 2, or
INPUT 3 is selected, respectively, by pressing the INPUT
Button.
The indicator will turn off after about 3 seconds from
selecting the input.
8
1 2 3 4 5 6 7
8 9 10 11 12 13
14
18
15 17
19
16
1
2
3
4
5
6