Honeywell 800-04433V1 - Manual (Page 10)

iPGSM-COM Commercial Fire Communicator – Installation and Setup Guide
– 8 –
Dialer Capture Module Information
LED Indicator STATUS
RED – Steady ON Messages exist in buffer.
RED – Flashing No messages to be sent. Waiting for messages.
GREEN – Steady ON Normal Indication.
GREEN – Blinks every 2 sec. PowerBoost1 communication problem.
GREEN – Blinks twice every sec. Communication Module connection is lost.
GREEN – Blinks 10 times every sec. PowerBoost1 and Communications Module connection is lost.
iPGSM-COM-004-V0
Dialer Capture Module
Telco 1
Telco 2
ECP
Tip 2
Ring 2
ZN-
EOL EOL ZN+
PWR GND Tip 1
Ring 1
Data Out
Data In 12V In
GND
RED
GREEN
LED Board Information
Panel Status LED Indicator
RADIO TROUBLE Yellow – ON when radio trouble is present.
Buzzer – Upon loss of AC power, this will
beep once every 10 seconds.
LOW BATTERY Yellow – ON when battery is low.
Yellow – (not used)
AC LOSS Yellow – ON when no AC is present.
AC ON Green – ON when AC is present.
Note: Telco ports 1 (primary dialer)
and 2 (secondary dialer) may be
used instead of the terminal board.
Whichever connection method is
used, both Telco paths must be
connected to the Fire Panel.
iPGSM-COM-006-V0
Buzzer