Honeywell MAGICSTAT CT2400 - Manual (Page 6)

COOLING PROGRAM
Weekdays Start Time Cooling
WAKE
RETURN
SLEEP
WAKE
SLEEP
If you decide not to enter weekend programs, SLEEP from the weekday program will copy to
the weekend schedule.
temperatures cannot be set any higher than 88° F [31 0 C] or any lower than 45° F [7°
NOTE: If you decide not to program the thermostat, it will automatically control heating at
68° F [20° C], and cooling at 78° F [26° C], 24 hours a day.
11
——- —
This guide can be used for programming your new thermostat.
NOTE: Batteries are required for operation and programming. When inserting batteries, set
system switch to OFF. Remove battery door (on thermostat left side) using a coin at the
bottom. Follow instructions on pages 6 and 7.
Set Current Time/Day T i m e
Ahead
To set time, press and release once, until current time shows; to set day,
Back
Time
until current day shows; then press .
Back
Heating Program
c 1
With system switch at HEAT, press and release once. “WAKE,” Mon-Fri and “SET”
appear on display.
12
Time Temp
c 1
Ahead Warmer
Use to program “WAKE time and to program “WAKE” temperature for
Back Cooler
Mon-Fri. Repeat sequence for “LEAVE,” “RETURN,” “SLEEP.”
Time
c 1
Ahead
Press until “WAKE,” “SA SU” and appear on display. Use to program
Temp
Back
— u
Warmer
“WAKE” time and ,—, to program “WAKE temperature for Sat-Sun. Repeat sequence
for “SLEEP.”
u
Cooler
Cooling Program
With system switch at COOL, follow the same instructions as for Heating Program.
After programming, adjust fan and system switches as desired. Press and release to
start the program.
13