Harmar Mobility AL500 - Manual (Page 14)

LIFT PREPARATION
HOLD DOWN ARM HEIGHT ADJUSTMENT
AL 560
LOOSEN BOLTS
TIGHTEN BOLTS
HIGHER ARM SETTINGS
CAN BE ACHIEVED BY
REMOVING TOP
SHAFT COLLAR,
RETRACTING
T HANDLE AND
RE-INSERTING ARM
FROM ABOVE.
THIS METHOD ALLOWS THE RED “T” HANDLE
TO REMAIN ON THE SAME SIDE AS THE KEY
AND TOGGLE SWITCHES.
DRIVE CHAIR ON PLATFORM
PULL RED “T” HANDLE
ROTATE ARM TO OVER SEAT
RAISE PLATFORM
UNTIL CLUTCH
DROP ARM
TO CONTACT SEAT
DROP ARM AGAIN
TO CONTACT SEAT
LOWER LIFT
APPROXIMATELY
2-3 INCHES
REPLACE
SHAFT
COLLAR
OR
VERIFY ARM PRODUCES
ENOUGH PRESSURE ON
SEAT TO FIRMLY HOLD
POWER CHAIR TO PLATFORM
SEAT SHOULD BE SOMEWHAT
DEFORMED BY ARM.
14