Heath Zenith Wireless Strobe Chime 6144 - Manual (Page 2)

-2- 598-1143-02
4. Adjust volume control (Available on se-
lected chimes). Unplug chime and adjust
volume control to desired volume (see Figure
2). Plug chime back into wall outlet.
5. Mount push button. Use either screws or
double sided tape to mount push button.
•
Screw Mounting: To mount with screws,
remove back of case by pushing in tab on
bottom with a small screwdriver (see Figure
1). Note: Remove material in screw holes
(if needed) before mounting with screws.
Attach back of case to door jamb or wall (see
Figure 3). Snap front of push button on.
• Tape Mounting: When attaching push but-
ton using double sided tape, make sure the
surface of the door jamb or wall is clean.
Chime Volume Control
(Selected Chimes)
Figure 3
TO
P
Figure 2
Jumper Access Door (See
Tune or Code Section)
CAUTION:
DISCONNECT
POWER BEFORE
OPENING
VOLUME