Heath Zenith Wireless Strobe Chime 6144 - Manual (Page 3)

-3- 598-1143-02
Your wireless chime has different selectable tunes: Ding-Dong (two flashes/two
notes/two flashes) or Westminster (eight flashes/eight notes/eight flashes). The
factory setting is for the Westminster tune. This tune can be changed by following
the instructions below.
•
Ding-Dong (Two note tune)
Strobe will flash two times, play the two note tune, then flash two more
times.
Inside Push Button: Add a jumper to location 8.
•
Westminster (Eight note tune)
Strobe will flash eight times, play the eight note tune, then flash eight more
times.
Inside Push Button: Remove jumper from location 8.
Note: Some models might require the use of
tweezers to remove and replace the jumpers.
Figure 4
1
2
3
4
5
6
7
8
Inside Push
Button
Tune Setting
V
O
LUME
1
2
3
4
5
6
7
Remove screw to
open access door
Back of Chime
Strobe/Tune Settings
WARNING: Disconnect chime unit from power source before
opening code access door. Close door and replace screw before
reconnecting to power.