Heath Zenith DUAL BRITE SL-5597 - Manual (Page 4)

4 598-1038-03
POSSIBLE CAUSE
1. A lamp is positioned too close to the
sensor or pointed at nearby objects
that cause heat to trigger the sensor.
(Reposition the lamp away from the
sensor or nearby objects).
2. Light Control is pointed toward a heat
source like an air vent, dryer vent, or
brightly-painted heat-reflective surface.
(Reposition sensor. Reduce Range).
3. Light Control is in Manual Mode.
(Switch to Auto).
1. Heat or light from the lamps may be
turning the Light Control on and off.
(Reposition the lamps away from the
sensor).
2. Heat being reflected from other ob-
jects may be affecting the sensor.
(Reposition sensor).
3. Light Control is in the Test mode and
warming up. (Flashing is normal un-
der these conditions. Turn Boost off).
1. Sensor is detecting its own lights.
(Reposition lamps to keep area be-
low the sensor relatively dark).
SYMPTOM
Lights stay
on continu-
ously.
Lights flash
on and off.
Lights flash
once, then
stay off in
Manual Mode.
SYMPTOM
Lights will
not come
on.
Lights come
on in
daylight.
Lights come
on for no
apparent
reason.
Lights turn
off too late
in Dusk-to-
Dawn
setting.
POSSIBLE CAUSE
1. Light switch is turned off.
2. Light is loose or burned out.
3. Fuse is blown or circuit breaker is turned
off.
4. Daylight turnoff is in effect (recheck
after dark).
5. Incorrect circuit wiring, if this is a new
installation.
6. Re-aim the sensor to cover desired area.
1. Light Control may be installed in a
relatively dark location.
2. Light Control is in Test. (Set control
switch to an ON-TIME position).
1. Light Control may be sensing small
animals or automobile traffic (re-aim
sensor).
2. Range is set too high. (Reduce Range
setting).
3. Dual Brite™ Timer is on.
1. Sensor is in a relatively dark location.
(Relocate sensor, or use 3 hr or 6 hr
setting).
TROUBLESHOOTING GUIDE
If you experience a problem, follow this guide.
See your Canadian Tire retailer for warranty information.