HP Photosmart D5400 series - Manual (Page 122)

DVD tray until the lines on the holder line up to the white lines on the tray and try your
print again.
Cause: You loaded the CD/DVD onto the CD/DVD holder incorrectly.
The product is printing on a non-printable area of my disc
Try the following solutions to resolve the issue. Solutions are listed in order, with the most
likely solution first. If the first solution does not solve the problem, continue trying the
remaining solutions until the issue is resolved.
• Solution 1: Change the software settings
• Solution 2: Load a new CD/DVD with the printable side up
Solution 1: Change the software settings
Solution: Make sure the design you are printing is appropriate for the size of the
media loaded in the CD/DVD holder, including the diameter of the inner and outer
rings. Change the software settings accordingly to center and size your design for the
disc you are using. Refer to the documentation or the online help of the software you
are using for additional information.
Cause: Your design was not the correct size for the CD/DVD you loaded.
If this did not solve the issue, try the next solution.
Solution 2: Load a new CD/DVD with the printable side up
Solution: If you have already burned your content onto the CD/DVD, you might
need to burn your contents again onto a new disc. Load the new disc onto the CD/
DVD holder with the printable side up. Reinsert the holder into the CD/DVD tray until
the lines on the holder line up to the white lines on the tray and try your print again.
Cause: You loaded the CD/DVD upside down on the holder.
The design is not centered on my disc
Solution: Change the software settings to center and size your design for the disc
you are using. Refer to the documentation or the online help of the software you are
using for additional information.
Cause: Your design settings were not correct.
CD/DVD print troubleshooting 121
Trou
bles
ho
ot
ing