HP PL4260N - Manual (Page 29)

Usi
n
g the
First-Time
Setup
Wizard
Using the First-Time Setup Wizard 19
Using the First-Time Setup Wizard
Initial Setup
When turning on the TV for the first time, a first-time
setup wizard walks you through the following:
■ Setting the onscreen display language.
■ Setting the date, time, and time zone.
■ Selecting a standby power mode.
■ Selecting a signal source.
■ Searching the TV signal source (antenna or cable)
and memorizing the available TV channels.
You can start the first-time setup wizard by using the
System menu in the onscreen display (OSD); see
“Starting the Setup Wizard” on page 40.
Preparing
Perform the following steps before you press TV Power
on the remote control unit.
1 Insert the batteries into the remote control unit.
2 Connect the antenna cable to the TV.
3 Plug in the AC cord to the AC outlet.
4 Turn on the TV.
Language setting
1 Select from among three languages: English,
French, and Spanish.
2 Press the up arrow and down arrow buttons on the
remote control to select the desired language
listed on the screen, and then press OK.
Date, time, and time zone setting
1 Press the up and down arrow buttons on the
remote control to highlight the date field.
2 Press the number pad buttons on the remote
control to enter a year, month, and day.
3 Press the down arrow button to highlight the
time zone.
4 Press the left and right arrow buttons to change
the time zone.
5 Press the down button to highlight the time field,
and use the number pad to enter the time.
6 Use the left and down arrow buttons to change
between AM and PM.
Standby mode setting
Select the standby mode setting.
■ Low power: Power-up time from standby is
approximately 20 seconds. However, the TV is
consuming less power while in standby.
■ Fast power: Power-up time from standby is
approximately 5 seconds. However, the TV
consumes more power while in standby.
Signal source setting
1 Press the up arrow and down arrow buttons on the
remote control to select Antenna or Cable.
2 Press the OK button to start searching for
channels.
This channel search operation automatically searches
for a signal from all available channels.