HP PL4260N - Manual (Page 50)

40 HP Plasma HDTV User’s Guide
Using the System Menu
Use the System menu to select the language for the
OSD menus, find the software version, start the Setup
Wizard, return OSD settings to default values, select
the Standby Mode, and start White Wash to reduce
the appearance of afterimage.
Starting the Setup Wizard
In the Setup Wizard menu, choose Yes, and press
OK. Then, turn off the TV, and turn it on again to start
the Setup Wizard.
Returning to Default Settings
In the Default Settings menu, return all settings,
including the channel list, to default value by selecting
Default Settings, and then pressing OK.
Using White Wash
In the White Wash menu, select Yes and press OK to
display an all-white screen for 3 minutes. This can
reduce the appearance of an afterimage resulting from
a fixed screen image.
Selecting the Standby Mode
(Power Control)
The Standby Mode menu setting can save energy. The
setting determines the power used by the TV when it is
turned off and enters standby.
■ Low power: Consumes less power while in
standby, uses approximately 20 seconds of
power-up time.
■ Fast power: Consumes more power while in
standby, uses approximately 5 seconds of power-
up time.
System menu Options
OSD ■ Language: English/
French/Spanish
■ OSD timeout: Short/
Middle/Long
Software Version Shows TV software
version number
Setup Wizard Start the setup wizard:
Yes/No
Default Settings Press OK to recover all
settings to default
values.
White Wash ■ Yes/No
Standby Mode ■ Low power
■ Fast power
n
Extensive use of White Wash may reduce
the lifetime of the panel.