Heath Zenith 3035748 (AC-6195) - Manual (Page 2)

-2- 598-1075-03
Code and Tune Settings
Code Settings
Note: Most installations will not require you to change any of the jumpers
on your chime and push button.
The push button and chime communicate by using a code that can be changed
by removing and/or adding jumpers on both the push button and chime. The
code is factory set; however, there are 128 selectable codes that allow you to
expand your system and prevent outside interference. Other wireless products
may cause interference and the system may not function properly. Follow the
instructions below for setting a new code.
1. Open the cases and locate jumpers on both the push button and chime (See
illustration on page 3).
2. The push button and chime both have eight different jumper locations. The
jumper positions 1 through 7 are used for setting the code.
3. To change the code, add and/or remove jumpers as needed. It is recom-
mended to only change one jumper at a time and then check to see if system
is functioning properly. Note: Jumpers in positions 1 through 7 must be exactly
the same for both the push button and chime for this system to function.
Tune Settings
Your wireless chime has different selectable tunes: Ding (one note), Ding-Dong
(two note), or Westminster (eight note) (Available on selected chimes). The
factory setting is for the Ding-Dong tune (or Westminster, when available). This
tune can be changed by following the instructions below.
•
Ding (one note tune)
Push Button: Add a jumper to location 8.
•
Ding-Dong (two note tune)
Push Button: Remove jumper from location 8.
Chime: Remove jumper from location 8.
•
Westminster (Eight note tune) (Available on selected chimes)
Push Button: Remove jumper from location 8.
Chime: Add a jumper to location 8.
Note: All models have both front and back door tune capabilities. You may pur-
chase any ACE
® wireless push button for a second entrance. We recommend
the back door use the Ding tune and the front door use the Ding-Dong tune
(or Westminster tune, available on selected chimes). Models that include two
push buttons will come factory set for front and back doors. Decals on the rear
of the push button will indicate its setting.