Heath Zenith 3035748 (AC-6195) - Manual (Page 3)

-3- 598-1075-03
Battery
Battery
Ba tte ry
1 2
3
4
5
6
7
8
1 2
3
4
5
6
7
8
Push Button Battery Replacement
Install an alkaline type A23 12 Volt battery. The
positive terminal should be positioned as shown.
* Code Settings 1-7
Must Match Both
Push Button and
Chime
Inside Push
Button
Inside Chime
Tune Setting
(Not used on
all models)
Troubleshooting
Chime does not sound:
• Make sure push button and chime codes are the same (See pages 2 and 3).
• Check orientation of push button battery (See page 3).
• Check charge of push button and chime batteries, replace if necessary.
Batteries seem OK, but the chime does not work when installed:
• Do not mount chime or push button on metal or near metal studs. This
reduces the transmitter range. Use 1/4" to 1/2" (6 to 13 mm) wood shims to
move chime or push button off metal surface.
• Concrete floors may reduce range. Move chime away from floor.
• Try locating chime closer to push button.
The range of the wireless chime can vary with location, temperature and bat-
tery condition.
ACE ® reserves the right to discontinue and to change specifications at any time
without notice without incurring any obligation to incorporate new features in
previously sold products.
Note: Some models might require the use of
tweezers to remove and replace the jumpers.
Tune
Setting