Hotpoint SD97PC - Manual (Page 9)

GB 9
Setting the time
You can only set the time if the mode selector is set to "0".
After the appliance has been connected to the power
supply (or following a power failure), a flashing "0.00" is
displayed. Press keys "+" and/or "-" to set the time.
The time set is memorised, but you still have another 3
seconds to modify it, as all the other buttons remain
disabled for that time.
Any changes to the time can be made by pressing button
r
and holding it down, until the time appears back on the
display and then pressing button
s
or
t
. Upon releasing
these buttons, the time set will be memorised, and you
still have another 3 seconds to continue your modification.
Minute Minder Feature
The timer can only operate with the oven switched off and
the function selector set to position 0.
Please remember that the timer does not control the start-
ing or stopping of the oven, it merely sounds a buzzer
when the time is up and can be interrupted at any time
just by pressing any button.
To set the timer, briefly press button
r
and then make
adjustments using
s
or
t
.
Upon releasing button
s
or
t
, the time set is memorised
but you still have another 3 seconds to continue making
any changes. The display will reset to show the time and
countdown will begin immediately. The
n
icon will remind
you the Minute Minder is on.
Once the countdown is over, a buzzer will sound, and will
stop doing so after 1 minute or if you press any button
whatsoever.
Please remember that the countdown is reset and the
n
icon comes off once cooking starts.
Buzzer volume
You can adjust the volume of the buzzer by pressing
button "-" (when the signal sounds) until you attain the
required volume.
Cooking without the programmer
When the oven is switched off (mode selector set to 0), all
the keys (except for "-" to adjust the volume of the acoustic
signal) are disabled.
Select a cooking mode by turning the function selector
clockwise. Each function has a predefined cooking time
that you can see by pressing . You can modify the
cooking time according to the recipes you use. Simply
press and choose the cooking time you require using
the “-” and/or “+”.
The display indicates a recommended temperature,
which is independent from that indicated on the
temperature selector: you can change it by turning the
temperature selector knob.
The grill display indicates a power level between 1 and 5
(1 for minimum power and 5 for maximum power).
Your oven is now ready to start cooking: press the
key. The oven begins the pre-heating phase, during which
symbol blinks. It stops blinking when pre-heating is done
(after approximately 10 minutes).
If you fail to press the cooking start key one minute after
having selected a mode, the word "OFF" comes up on the
display and the keys are disabled. In this case, set the
mode selector back to "0" and proceed with the various
adjustments.
Indicator light for a programmed
operation:
- lit : operation underway
- off: operation finished
- flashing: programmed operation
has finished
Letter A:
- off: manual mode
- lit: an operation has been programmed
Display for all functions : clock, timer,
cooking duration and
end-of-cooking/fast-cleaning time
Timer indicator light
Button to set the timer
Buttons + and - to set the clock, timer,
cooking duration and end-of-operation
time, press on:
+ to increase the time
- to reduce the time
Button to start cooking
Button to set the
cooking duration
Button to set the
end-of-cooking time
5 s.
Auto A
The Programmer