Hand Held Products 5620 - Manual (Page 29)

IMAGETEAM™ 2020/5620 System Manual 1 - 13
2. Disconnect the keyboard cable
from the back of the terminal/
computer.
3. Connect the
appropriate
interface cable
to the base and
to the terminal/
computer and
keyboard.
4. Turn the
terminal/
computer power
back on.
5. Program the
base for the
keyboard wedge interface. See
"Keyboard Wedge Connection" on page 1-
15.)
6. Verify the base operation by scanning a bar code from the Sample Symbols
in the back of this manual.
Note: Without using the 9-volt external, power supply, the base only uses
enough power from the host to operate the interface. The scanner’s
battery is not charged when in this mode. Using the 9-volt, external power
supply allows the scanner’s battery to be charged, and no power is drawn
from the host.
Disconnect
1
2
3