Harbor Freight Tools 42654 - Manual (Page 8)

Page 8 SKU 42654 For technical questions, please call 1-800-444-3353.
REV 01/05
To Install A Saw Blade:
Caution: Prior to installing the Saw Blade (70), make sure the Compound Miter
Saw is disconnected from its electrical power source.
Caution: Never use a Saw Blade larger or smaller in diameter than 8-1/4”, and
rated less than 4,500 RPM operation.
CLIP
WASHER
WRENCH
FIGURE C
DEEP
SOCKET
WRENCH
NOTE: This procedure requires the use of the Deep Socket Wrench and Clip Washer
Wrench tool accessories.
(See Figure C.)
EXHAUST PORT HEX SCREW
(#45)
FRAME (#50)
HEX SCREW (#45)
CLIP WASHER
(#71)
BOLT (#73)
WASHER (#72)
LONG SCREW
(#37)
FIXED BAR
(#34)
FIGURE D
Insert the two prongs of the Clip Washer Wrench into the two holes in the Clip Washer
(71), and hold the Clip Washer in place to prevent the Shaft (62) from turning.
(See
Figures C, D, and Assy. Diagram.)
Use the Deep Socket Wrench to unscrew and remove the Bolt (73), Washer (72),
and Clip Washer (71).
(See Figures C, D, and Assy. Diagram.)
1.
2.
3.
4.
5.