Heath Zenith PF-4290 Series - Manual (Page 5)

5 598-1234-02
❒ If you need to change the sensitivity,
temporarily remove the fixture and make
the adjustment. Too much sensitivity may
increase false triggering.
❒ Set the amount of TIME you want the light
to stay on after motion is detected. (1, 5,
or 10 minutes).
❒ Set the amount of time after dusk you want
the lights on accent level.
SPECIFICATIONS
Range .........Up to 30 ft. (9.1 m) [varies with
surrounding temperature].
Sensing Angle.............................Up to 150°
Electrical Load .... Up to 100 Watt Maximum
Incandescent.
Sensor Capacity ..... Up to 360 Watt (3.0 A.)
Maximum
Power Requirements ......... 120 VAC, 60 Hz
Operating Modes ............ TEST, AUTO, and
MANUAL MODE
Time Delay ........................ 1, 5, 10 minutes
D
ual
B
rite
® timer .....3, 6 hrs, Dusk-to-Dawn
DESA Specialty Products reserves the right to
discontinue products and to change specifica-
tions at any time without incurring any obliga-
tion to incorporate new features in products
previously sold.
❒ Walk through the coverage area noting
where you are when the lights turn on.
Move the sensor head left or right to
change the coverage area.
Rotating Sensor Head to Change
Coverage Area
IMPORTANT: Grasp the sensor only as
shown and turn the entire sensor. Any
other method may damage the sensor.
Do not force the sensor past the stop-
ping points.
15
0°
150
°