HoMedics IB-BPW060A - Manual (Page 17)

TRouBLESHooTING
If any abnormality arises during use, please check the following points:
Note: If the unit still does not work, contact HoMedics Consumer
Relations. Under no circumstance should you disassemble
or attempt to repair the unit by yourself. Contact informa-
tion for HoMedics Consumer Relations Department can be
found on the warranty page (See page 34).
32 31
SYMPTOMS
POSSIBLE
CAUSES
CORRECTION
Unit does not
turn on when the
START/STOP
button is pushed.
Batteries have run
down. Replace them
with two new AAA
alkaline batteries.
Battery polarities
have been positioned
incorrectly. Re-insert the
batteries in the
correct positions.
EE measurement
error symbol shown
on display or the
blood pressure
value is displayed
excessively low (or
high). Cuff has been placed
incorrectly. Wrap the cuff
proerly so that it is
positioned correctly.
Did you talk or
move during
measurement? Measure again.
keep wrist
steady during
measurement.
Shaking of the wrist
with the cuff on.
E1 error symbol
shown on display Air circuit
abnormality. Measure again.
E2 error symbol
shown on display Inflation pressure
exceeding 300 mmHg. Switch the unit off,
then measure again.
E3 error symbol
shown on display Error determining
measurement data. Measure again.
PoTENTIAL foR ELECTRoMAGNETIC
INTERfERENCE
To avoid inaccurate results caused by
electromagnetic interference between
electrical and electronic equipment, do
not use the device near a cell phone or
microwave oven.